把纸平放在离心机放鞋子的托盘上，样品鞋牢固地固定在托盘里，然后往鞋子内部加入一定深度的水，最后启动机器，
托盘在带有垂直轴的离心机上，由慢速至中速直至高速地旋转，这样水鞋子里面的水就对鞋子内部施加一定的压强，此压强远大于人脚正常穿着，运动时外部水对鞋面材料的压强，
更远大于目前有些传统测试，“脸盘泡水”产生的压强，检测时间一般为30-60分钟，防水检测结束，打开离心机把样品取出，
如鞋子漏水，放在托盘的纸就会湿，同时，离心机外围的透明亚克力也会出现明显的水珠，最后把鞋子里的水倒出，用烘干机进行烘干，最后解剖样鞋寻找漏水原因，进而进行改善。
Put the paper on centrifuge tray of the
shoes.Sample shoes firmly fixed in the tray,Then the shoes inside in certain
depth of water,The final rev.Move the machine,
Tray on the centrifuge with vertical
axis,From a slow to medium speed until the high-speed rotation,So water the
inside of the shoes for shoes inside Add a certain pressure,
The pressure is greater than human feet
normal wearing,Farther than the traditional test,"Face bubble water"
produced by the pressure, testing time is 30 to 60 minutes commonly, waterproof
testing end, open the centrifuge to remove the samples, such as leaky shoes,In
the paper tray will wet,
At the same time, the centrifuge peripheral
transparent acrylic also can appear clear water, finally, the water poured out
of the shoes, use the dryerDrying, and finally the anatomy of the sample shoes
to find leakage causes, and then to improve.
主营产品：袜套测试机,防水贴条机,压胶机,高透防水测试机,面料测水压机,成品鞋烘干机,防水条机,防水鞋机,防水压胶机,热气缝合密封机等